Playing around with SmartyCam Graphics...
#1
Rennlist Member
Thread Starter
Playing around with SmartyCam Graphics...
Spent a little time this weekend playing around with the ability to add graphics (logo’s) to smarty-cam screen, and made a few gauges using the generic bar. Lower left are temps, with pressures next to that. Not sure if any of this will help anything, but I was mapping all these to make sure the units were correct, so I made the gauges. Anyone got any other tricks like this?
The one thing I found interesting is that it appears smartycam assumes some conventions (ie: pressure in bar, and temp in C), so even though your temp is in F, you may need to pick C for it to display correctly. However, the MoTeC data comes over to dash in metric, so I pick F and it’ll display correct.
The one thing I found interesting is that it appears smartycam assumes some conventions (ie: pressure in bar, and temp in C), so even though your temp is in F, you may need to pick C for it to display correctly. However, the MoTeC data comes over to dash in metric, so I pick F and it’ll display correct.
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,172
Received 3,341 Likes
on
1,896 Posts
Nice! This is cool!
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway