Mahle Cylinders - Honing problems
#1
Nordschleife Master
Thread Starter
Mahle Cylinders - Honing problems
FYI
We have expierenced a problem with Mahle 95mm and 100mm cylinders where the honing is at a 5 degree angle, not the normal 60 degree angle. We have contacted Mahle Germany through a contact at Mahle Motorsport here in the US. There is acknowledgement that there is a problem, a recommendation not to run them, but no resolution as of yet. If you order new piston and cylinder sets, please check them and contact your supplier if you find them to be honed incorrectly. I have not used any other bore sizes and have had several other shops I work with check their stock and they have also found 95mm and 100mm with problems.
We have expierenced a problem with Mahle 95mm and 100mm cylinders where the honing is at a 5 degree angle, not the normal 60 degree angle. We have contacted Mahle Germany through a contact at Mahle Motorsport here in the US. There is acknowledgement that there is a problem, a recommendation not to run them, but no resolution as of yet. If you order new piston and cylinder sets, please check them and contact your supplier if you find them to be honed incorrectly. I have not used any other bore sizes and have had several other shops I work with check their stock and they have also found 95mm and 100mm with problems.
#3
Rennlist
Basic Site Sponsor
Basic Site Sponsor
__________________
Larry Herman
2016 Ford Transit Connect Titanium LWB
2018 Tesla Model 3 - Electricity can be fun!
Retired Club Racer & National PCA Instructor
Past Flames:
1994 RS America Club Racer
2004 GT3 Track Car
1984 911 Carrera Club Racer
1974 914/4 2.0 Track Car
CLICK HERE to see some of my ancient racing videos.
Larry Herman
2016 Ford Transit Connect Titanium LWB
2018 Tesla Model 3 - Electricity can be fun!
Retired Club Racer & National PCA Instructor
Past Flames:
1994 RS America Club Racer
2004 GT3 Track Car
1984 911 Carrera Club Racer
1974 914/4 2.0 Track Car
CLICK HERE to see some of my ancient racing videos.