Durametric Tool Cannot Access Stability Management Module
10-30-2016, 08:05 PM
#1
6th Gear
Thread Starter
Join Date: Apr 2016
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Durametric Tool Cannot Access Stability Management Module
I have a 2006 Porsche Cayenne S. I cannot access the Stability Management module with my Durametric tool. I have tried a replacement cable from them, but it did not help. I have logged the situation, but Durametric does not have a solution for me. Everything works fine in the vehicle including ABS, traction control, etc. Any help would be greatly appreciated, thanks! Here is a video of the issue:
10-31-2016, 04:07 AM
#2
My guess - communication part of the module is faulty
Only way to know for sure it to swap it and see if that clears the issue but before I do that I`d check all the wiring to it as a first step
Only way to know for sure it to swap it and see if that clears the issue but before I do that I`d check all the wiring to it as a first step
10-31-2016, 01:38 PM
#4
In my opinion - yes
Think about it like this, if the wifi on your laptop (i.e. the communication part) crapped out most likely the rest of the laptop would still work just fine so it is possible for some aspects to fail in isolation and not affect others
Think about it like this, if the wifi on your laptop (i.e. the communication part) crapped out most likely the rest of the laptop would still work just fine so it is possible for some aspects to fail in isolation and not affect others
