Rennlist - Porsche Discussion Forums - Conversation Between V2Rocket and sffranco

Go Back  Rennlist - Porsche Discussion Forums > V2Rocket
Reload this Page >

Conversation Between V2Rocket and sffranco

Conversation Between V2Rocket and sffranco
Showing Visitor Messages 1 to 4 of 4
  1. V2Rocket
    09-13-2017 12:08 PM
    AS I RECALL the clip is there to retain the original flywheel damper thing.
    my memory may be fuzzy though, it's been years and years since i've even seen an automatic944
  2. sffranco
    09-13-2017 10:37 AM
    Thanks for reply. Yep, I'll try to get clip back on there. Regarding "held in place on transmission end", if that's the case then why is it needed (the clip) to begin with. (just to be clear, I have an '86 944 A/T, and replacing my broken damper plate with a manual clutch setup from an '86 944)
  3. V2Rocket
    09-13-2017 12:06 AM
    the driveshaft should not be able to move because it will be held in place at the transmission end.
    that said if you can get the clip in there i would put it back
  4. sffranco
    09-12-2017 08:39 PM
    Hey V2Rocket...I was just reading some posts on swapping out damper plate with a M/T clutch setup. Question: when doing do, is the little shaft circle clip needed any more ? If not, what would keep the drive shaft from walking back toward transmission ? Thanks much for your help. As you could guess, I am about to perform this swap but this circle clip was not mentioned in any of the discussions I read on the topic. thanks , Steve

Contact Us Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.