Rennlist - Porsche Discussion Forums - Conversation Between Dougs951S and vetter59

Go Back  Rennlist - Porsche Discussion Forums > Dougs951S
Reload this Page >

Conversation Between Dougs951S and vetter59

Notices
Conversation Between Dougs951S and vetter59
Showing Visitor Messages 1 to 1 of 1
  1. vetter59
    08-21-2016 05:47 PM
    Hi Doug, I actually have 3 gouged/scratched blocks already. I talked to several weeks ago about '88 N/A pistons a few weeks back for the same car, which I believe I will be able to save and re-use by sending them to Calico Coatings, and having them re-coat piston skirts with CT-3 dry film lubricant.
    So are you saying that I am better off having my original block re-done? US Chrome in Wisconsin will put in new Alusil liners for about $945 not including shipping. Re-coating pistons about $250. 2] option would be to put steel liners, and wossner or chevy piston /ring set. Then Gaskets and bearings, rings, seals ect will probably have about $1700-1800 in short block by time I'm finished. 3] Found a low miles '87 with 77k was pristine before it was rolled, engine still in car, could hear it run before they take it out for $840.
    So I know third option the cheapest, but it would have a little less HP, but also only want to do it once! which way would you go with this?

Contact Us - About Us - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.