Mark this thread as Unsold
For Sale: Brey Krause BK1030 996/997 Coupe Harness Mount Bar
08-24-2011, 06:41 PM
#1
Drifting
Thread Starter
Brey Krause BK1030 996/997 Coupe Harness Mount Bar
Like new. Buyer pays shipping.
Use for harnesses when you don't want to install a full roll bar/cage.
996/997 coupe (without Bose speakers)
$350.00 +shipping
The harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking.
Bars is easy to install and remove, use only existing holes and mounting points, and will not damage the car in any way.
Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. A mount really can't be relied on unless it has been tested to support the loads required by the National Highway Traffic Safety Administration.
Certain power seats may interfere with installation of floor brackets. Please contact us for alternate part if necessary.
The Brey-Krause Harness Mount supported the loads specified by the National Highway Traffic Safety Admin. DOT for upper torso restraints in all automobiles. Tensile tests performed by an independent lab.
Material: Type 304, stainless steel.
Finish: Powdercoated in durable black wrinkle-finish.
Weight: 16lbs.
Models: 996/997 Coupe (without Bose Speakers)
Installation: Bar attaches to rear strut tops & seat belt mounting points and is easy to remove/reinstall.
Miscellaneous: Bar is designed to allow enough seat travel for tall drivers.
Use for harnesses when you don't want to install a full roll bar/cage.
996/997 coupe (without Bose speakers)
$350.00 +shipping
The harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking.
Bars is easy to install and remove, use only existing holes and mounting points, and will not damage the car in any way.
Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. A mount really can't be relied on unless it has been tested to support the loads required by the National Highway Traffic Safety Administration.
Certain power seats may interfere with installation of floor brackets. Please contact us for alternate part if necessary.
The Brey-Krause Harness Mount supported the loads specified by the National Highway Traffic Safety Admin. DOT for upper torso restraints in all automobiles. Tensile tests performed by an independent lab.
Material: Type 304, stainless steel.
Finish: Powdercoated in durable black wrinkle-finish.
Weight: 16lbs.
Models: 996/997 Coupe (without Bose Speakers)
Installation: Bar attaches to rear strut tops & seat belt mounting points and is easy to remove/reinstall.
Miscellaneous: Bar is designed to allow enough seat travel for tall drivers.
Last edited by savyboy; 09-24-2011 at 01:44 PM.
), so I have forwarded the info.