987.2 - Solo 2 DL water temp reading
07-16-2024, 01:00 PM
#1
Rennlist Member
Thread Starter
987.2 - Solo 2 DL water temp reading
Hello everyone, I recently got a Solo 2 DL installed on my Cayman R, hardwire to CAN, Siemens ECU selection in RaceStudio. Oil temp, Oil pressure and fuel level all appear to reading perfectly but water temp is giving me weird reading when the car is cold. When the car has sat for days and is at ambient temperature the oil temp will ready as such (about 90 degrees recently) but water temp will be ~132 degrees. I have swapped the sensor and it still read out ~132 when cold. Once the car comes up to temp, water will read in the ~200s while oil will sit around ~184. Does anyone know if this is the bottom of the sensors capability or if I may have a wiring or Aim config issues?
07-16-2024, 01:03 PM
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,180
Received 3,344 Likes
on
1,899 Posts
Sounds like correct operating temps sitting there.
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
