When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I may just do that. Finally got the hose off, what a pain. I tried to get the fitting to come out, while at the same time trying to not cause any bends, but no luck. Perhaps pin and put JB on what exposed areas there are.
I may just do that. Finally got the hose off, what a pain. I tried to get the fitting to come out, while at the same time trying to not cause any bends, but no luck. Perhaps pin and put JB on what exposed areas there are.
Will need a torch to heat and remove the fitting, Not sure about what your up against I had the coolant manifold off when I did my 997TT
Not looking forward to doing this again.
What year is your 958?
The one I've got from AliExpress two days ago is just fine.
I've been debating about getting a carbon one and I think this convinced me; my main concern has been it will clash or look vastly different then the OEM carbon. It looks fairly close in the picture, is that your impression in person?
Will need a torch to heat and remove the fitting, Not sure about what your up against I had the coolant manifold off when I did my 997TT
Not looking forward to doing this again.
What year is your 958?
2013 with about 91k miles. If only I had the manifold off, I'd probably thread the hole and put a threaded fitting like the one method in the DIY. And yes, definitely do NOT want to do this again.
I've been debating about getting a carbon one and I think this convinced me; my main concern has been it will clash or look vastly different then the OEM carbon. It looks fairly close in the picture, is that your impression in person?
The pattern of the carbon on the shifter I had originally from the factory is smaller. But the new one looks harmoniously once installed.
So I found out the hard way that the cup holders are super shallow and any spirited driving will detach ANY refreshments from their appointed holding area 😲☹️🤬. Has anyone found or come up with some type of riser to secure drinks better?
This too happened to me during hard braking while turning (freeway offramp)... thankfully my beverage holder held water... also thankfully, this didn't occur in the morning when the beverage holder held coffee.
It seems to me the carbon pattern on the new one looks quite appropriate.
The original one looks more sporty and the carbon matches perfectly. The giant shifter looks more luxury and the carbon is laid out in a 45° orientation. All the other factory carbon looks to be laid out in a straight pattern.
The original one looks more sporty and the carbon matches perfectly. The giant shifter looks more luxury and the carbon is laid out in a 45° orientation. All the other factory carbon looks to be laid out in a straight pattern.
Very correct. I wonder whether the original exclusive carbon shifter looks the same or it is a kind of "Chinese art".
Just now made a quick check. Seems there is no original exclusive shift **** with carbon finish, they are only in leather. So definitely Chinese art )))))))