Radio pinout.
2 Attachment(s)
I need to get my navigation disk out of my unit. Can I put 12 volts on it and use the eject button? If so, can someone point me to the 12 volt positive pin (assuming the case is ground)? I assume the fuse is the main power. Can I take the fuse out, put it in series with a 12 volt supply and alligator clip it to one of the fuse sockets in the radio. Not sure which one though.
|
|
Thanks KevinMacd. So, I assume the lower right pin is A5?
|
|
Hi...i am a new user here. As per my knowledge The problem with integrating all controls into a single computer controlled interface is that it can take much more time to access the feature you want, especially when the car is moving and not stationary.Simple things like climate control settings, radio on/off/volume/track selection, traction control/stability control settings, etc, are far easier to control with simple buttons and knobs than navigating through a computer interface which often makes you go through menus to get to the function you want, especially when you are actually driving.
pcb assembly |
All times are GMT -3. The time now is 10:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands