991 Side Skirts on 997.2 C2 - DONE!!! DIY Below
06-27-2018, 06:00 PM
#47
Rennlist Member
06-27-2018, 06:16 PM
#48
06-29-2018, 11:06 AM
#50
Burning Brakes
Thread Starter
Originally Posted by Monty Bhatia
This looks amazing! Great work!
This may be a dumb question but would something like this work for a 991.2 base?
I find the sides could have a little more to them as I have put on the sports design front lip.
I'm not sure if putting on a 991.2 would require any sort of modification like above.
I think the 991.2 GTS has these on them, but understanding the rear of the car is wider than the base.
Thanks
This may be a dumb question but would something like this work for a 991.2 base?
I find the sides could have a little more to them as I have put on the sports design front lip.
I'm not sure if putting on a 991.2 would require any sort of modification like above.
I think the 991.2 GTS has these on them, but understanding the rear of the car is wider than the base.
Thanks
06-29-2018, 11:07 AM
#51
Burning Brakes
Thread Starter
Originally Posted by Torxuvin
I'm adding this to my summer project list. I love how it turned out. I'd like to see yours in person at some point since you're local. I'm up in Gwinnett.
07-13-2018, 01:38 PM
#53
Someone should just sell this as a direct bolt on kit for the 997. I’m sure the less skilled people like me would pay extra for their labor for a bolt on side skirt.
The following users liked this post:
Murphey997 (01-11-2020)
07-28-2018, 12:36 AM
#54
Burning Brakes
Thread Starter
Revision #3 added to pg 1 of the thread (initial post).
Now includes custom designed front end caps for the side skirts.
Now includes custom designed front end caps for the side skirts.
07-28-2018, 12:51 PM
#56
Think those end caps up front just make the whole project perfect. Great finished, professional look!
Are the end caps something readily available and repurposed for this project? Or custom fabricated? If fabricated, they look very, very well done!
Are the end caps something readily available and repurposed for this project? Or custom fabricated? If fabricated, they look very, very well done!
07-28-2018, 01:16 PM
#57
Burning Brakes
Thread Starter
I designed the end-caps from scratch (CAD) as there was nothing out there off-the-shelf that could fit the purpose. Then produced the parts with an Industrial 3D printer using the same type of plastic as OEM.
07-28-2018, 01:50 PM
#60
Burning Brakes
Thread Starter
Originally Posted by amplitude
Those caps look great! Are they something you might offer for sale to those wanting to give this same project a try on their own cars?
Will send you a PM.