When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Car needs an alignment so I only put a few easy miles on them in the meantime to make sure everything felt tight. They're height adjustable and definitely stiffer then eibach springs they replaced but not bad overall. I also have a DCS controller which I will install after I put a few miles on these which will soften them up a bit in non-sport PASM setting. Excited to actually give them a proper test run on some back country roads.
where did you find the 997.2 gt3rs factory setup? I am definitely interested in this same setup!
Annual oil change on the RUF car today. Did a out a 20 minute spirited drive to get the oils hot / God I love this car.
9.5 qts of DT40 in and a new K&N spin on filter. I'll adjust the level the next couple mornings and it usually needs about 1/2 QT more (I have the MantisSport deep sump). Cut open the filter to find essentially nothing - a couple of teeny, tiny flecks of aluminum and 1 really tiny piece of hard plastic tensioner paddle guide. I'll send the sample off to Blackstone just to make sure.
What is your ride height and alignment? I’m running 5mm / 10mm spacers with factory SPASM suspension and the same wheels. The front are perfect, but I feel like the rears poke out a little bit.
03-16-2019, 09:28 AM
