Drained oil completely, put in exactly 8.7 quarts (997.1), oil level still high
#16
RL Community Team
Rennlist Member
Rennlist Member
As others have said, yes, that's over full. If the segment is solid it's only a little over full, if flashing, it's a lot overfilled, but I can't quantify those.
#17
After 3 times releasing the oil filter canister and 1.75 quarts were removed. The computer form the cluster told me to wait for 30 minute while the ignition key in on. Now it’s at the bottom of the mark. I think i should drive it for a couple of miles
This is what I took out
#18
RL Community Team
Rennlist Member
Rennlist Member
After 3 times releasing the oil filter canister and 1.75 quarts were removed. The computer form the cluster told me to wait for 30 minute while the ignition key in on. Now it’s at the bottom of the mark. I think i should drive it for a couple of miles
This is what I took out
#19
Marucus, your initial meter is what mine looked like after adding 8.7 qt. I dumped a single filter of oil and now I'm within the correct range. Seems like you went too far. The gauge seems very sensitive.
#20
Stupid gauge. Mine was on the blinking bottom line. Put in 1/2 qt. Drive around. Still blinking. Put in other half. Drove around. Showed full like OP's the next morning. Drove a few miles, showed two big bars since.
Gimme a dipstick.
Gimme a dipstick.
The following users liked this post:
sierra73 (03-03-2024)
#21
RL Community Team
Rennlist Member
Rennlist Member
Peace
Bruce in Philly