The Prestige Thread - Finest 996TT Market Finds
#2838
RL Community Team
Rennlist Member
Rennlist Member
#2839
RL Community Team
Rennlist Member
Rennlist Member
If the crank and engine cases are reusable I could probably rebuild the engine for much less than that; that's assuming my labor cost is $0. I already have the bearings, gaskets, and seals on hand (I like to be prepared). I bet it's got broken piston rings or perhaps piston damage like burned ring lands, or the valve guides are totally shot. I don't have the free cash at the moment or this would be very tempting indeed.
#2841
RL Community Team
Rennlist Member
Rennlist Member
No.
'BEST' was dripping with sarcasm...
'BEST' was dripping with sarcasm...
#2842
RL Community Team
Rennlist Member
Rennlist Member
However, I am intrigued by 'tilt steering column'...
The following users liked this post:
bdronsick (12-08-2021)
#2844
RL Community Team
Rennlist Member
Rennlist Member
#2846
RL Community Team
Rennlist Member
Rennlist Member
Seems legit...
#2847
RL Community Team
Rennlist Member
Rennlist Member
Truth is, I'm just going by what you guys say - my firewall is acting up and I cannot get on the site...
#2848
Drifting
Well the other side of the spectrum is they actually know the cars, which is worse IMO.
Case in point: I looked at a 6GT2 in Chantilly yesterday and the owner rushes right over to inform me they've taken it off the market "until further notice". Turns out they're just waiting to relist at $250K (from $150K).
BTW that one obviously didn't have the "tilt steering column"
Case in point: I looked at a 6GT2 in Chantilly yesterday and the owner rushes right over to inform me they've taken it off the market "until further notice". Turns out they're just waiting to relist at $250K (from $150K).
BTW that one obviously didn't have the "tilt steering column"
Last edited by bdronsick; 12-08-2021 at 02:06 PM.
#2850
RL Community Team
Rennlist Member
Rennlist Member
THAT would be an impressive, and RARE, option to have...