dporto

Bummer... I can't wait. I'm hoping to have the flywheel back on and the new clutch in by the end of the week...

Chris(MA)

heres some pics of my version, a proto i used on my 996 in the last few weeks. worked great! alas i am n the middle of nowhere in italy right now with bad internet on vacation so wont be filling orders for at least a couple of weeks

Chris(MA)

works great

dporto

Nice! Does the plastic want to flex as you're tightening those bolts? How many turns can you put on a bolt before moving across to the next ? 1 turn ea.?

dblvanos

I am a sucker for tools.

When I bought this I thought it would hold value pretty well, all the 3d printed tools you all are making has me thinking I could be wrong.

shorty996

Hi Diamond i would also buy one asap.....
let me know..

thx
Mikel

RRTEC

Another 3D printed tool... worked well.

Chris(MA)

no flex, i start with a small tap to engage the seal then screw down. i put about 1/2 turn each to ensure even pressure on the seal

this design was i think revision 5, i like the open design so can visually see the crank end as it goes on.

the part is very sturdy, it should last hundreds of uses at least

dporto

How much would you sell it for?

Diamond Blue

Will get an update tomorrow with eta from the shop

win911

Hi, what would be the cost of this tool?

Diamond Blue

These are now ready. Sorry about the delay on these.My daughter was in a bad crash. The cost for these are $70.00 shipped in the USA. Here are some pictures. There are 10 available. Anyone who said they want one will get one. PM me for paypal or Venmo. thanks, Michael