Friday Project...wish me luck
07-05-2019, 11:35 PM
#2
Make sure to tape up your hand brake handle. It can get beat up while installing the console. (From experience)
07-05-2019, 11:36 PM
#3
Rennlist Member
Good luck sir!
It is just finishing the paint and clear that gets me every time. I have a CF ebrake to install as well
07-06-2019, 01:20 AM
#6
Rocky Mountain High
Rennlist Member
Rennlist Member
Looking forward to seeing the final product!
07-06-2019, 01:38 AM
#7
Three Wheelin'
looks fun. what did you do to prep?
Trending Topics
07-06-2019, 02:04 AM
#8
Race Car
Thread Starter
Well I took alcohol to it then acetone and then have put three or four layers of color enlight spray over the top of it. Usually the issue I have is with the clear and it getting laid down. So that's where I'm a little scared as to do I sand it in what happens at that point.
07-06-2019, 04:14 AM
#11
Race Car
Thread Starter
All right ladies and germs it's ready to go back in I think I actually did it right this time. The sanding was scary but it actually worked
Last edited by Tim Wasmer; 07-06-2019 at 05:03 AM.
The following 3 users liked this post by Tim Wasmer:
07-06-2019, 10:16 AM
#13
Rennlist Member
Wow, looks incredible! Any other accents to go with the bold color choice?
07-06-2019, 12:03 PM
#14
Rocky Mountain High
Rennlist Member
Rennlist Member
Nice job!
