993 Rebuild & More
#274
Rennlist Member
Thread Starter
Bearing and hub install
holding down the hub while pulling the hub. I dont have a Grappler Puller
bearing is out and hub is ready
pressing in the bearing
pressing in the hub
testing the magnetic sensors on the scope, just in case
it spits out a wave pulse when spun
Hubs are ready
#277
Rennlist Member
Thread Starter
My calipers had been spray painted red then yellow before I started to try stripping them. They were originally black
I decided to go with red powder coating. The company I used would include sand blasting so I stopped trying to clean off the old paint and prepped them for the blast
Removing the old seals and guide plates Yikes this was no weekender for me
I decided to rebuild and get the caliper powder coated
i went with red and Centric seals on the Bembos
#280
Rennlist Member
Thread Starter
Seals and assembly lube from Zeckhausen Racing
Cleaning out the threads
More cleaning
I used locktite red 272 for the guide plate bolts
I got my Centric seals from Zeckhausen
#283
Rennlist Member
Looking good Glenn! When you re-mated the caliper halves, did you use anything to re-seal the faces, or just metal to metal? Also, what did you use for a torque spec for the bolts holding the halves together? I couldn’t find any info on splitting and re-mating the caliper halves