ca993twin

When I bought Rufus, I also bought a used LWF and clutch parts. The story I was told at that time was that the previous owner had these parts installed, but was disappointed with stalling issues, and went back to a stock, dual mass flywheel and stock clutch parts. These have been in a box in my garage ever since. I finally took some photos and wrote down some part numbers, but I'm not sure if I have all the numbers right. Here is what is in the box:

1) a new PP but the fingers seem to be bent. It also has a new T/O brg attached, perhaps incorrectly? PP: 964.113.028.69 (Sachs). T/O brg: 8161.172.909 (Sachs). First two photos.

2). a used PP: 88.3082.999.750 (Sachs Race Engineering). Photos 3 and 4.

3). a used clutch disk: 1862.323.031 (Sachs). Photos 5 and 6.

4. A LWF with ring gear and pilot bearing: 964.102.239.31 (these numbers are BACKWARDS! I had to read them with a mirror!). photos 7 and 8.

I would like $1000 plus shipping for all this stuff.

Steve (ca993twin@yahoo.com)

pirahna

I hope this doesn't mean that you are giving up on buying another 993?

ca993twin

I'm not sure what direction I will go for my next "fun" car, or even if I will have a "fun" car. I'm enjoying thinking about it, and exploring. Cayman? Aston Martin V8 Vantage? Austin Healey? Morgan? GT3? 993? 997? Viper?

Why isn't there any interest in this LWF and clutch parts? Am I asking too much money?

cgfen

uncertain
but i know i would not buy used clutch parts of somewhat unknown provenance.
R&Ring is a lot of work go through to put used stuff in a car.

likely market is a person that is uber familiar with these parts, can do a visual inspection to determine their "air-worthiness" and will then perform the install themselves.

just my opinion.

GLWTS

Craig

OverBoosted28

Someone will eventually need these items. Just keep "bumping" it up to top periodically and make sure they know "OBO". If it's on the first page of the classifieds, the time when someone decides they need one and start looking, you'll get interest.
GLWS

ca993twin

Does anybody want these parts for $800? I'd like to clear out my garage.

ca993twin

Bump. Anybody?

ca993twin

Bump. I'll accept almost any offer. I need to get this out of my garage!

quacktoduck

will this fit a NA car? if so i may be interested.

ca993twin

I'm not sure. I'm hoping someone knowledgeable can answer this. Please.

quacktoduck

i looked at the parts. i think im gonna have to pass due to the cost and the parts that i cannot use and factoring the cost of the parts new.

thanks

quacktoduck

oh FYI

these parts should fit N/A cars. the main difference is the pressure plate which i assume is from a Turbo car. The turbos had a higher pressure plate force.
unfortunately the new one looks like its not salvageable. i would most likely not put in the used pressure plate for piece of mind.

The best bet is to sell the LWFW as and have the new owner get it resurfaced ($100ish for resurfacing)

thanks