Help: Recaro Pole Position install
#1
Three Wheelin'
Thread Starter
Join Date: May 2004
Location: SH, NJ
Posts: 1,317
Likes: 0
Received 0 Likes
on
0 Posts
Help: Recaro Pole Position install
For those who have installed Recaro Pole Positions and still have the original seatbelts. Do I need a special bracket to mount the seatbelt to the floor/rail/bracket? As it stands, I cannot fasten the seatbelt at the original position.
If I do need this bracket, where can I purchase this?
Thank you very much for the help
If I do need this bracket, where can I purchase this?
Thank you very much for the help
#2
Agent Orange
Rennlist Member
Rennlist Member
IIRC I used the rear seatbelt receptors on mine, and bolted them to the mounting point of the bracket with the seat. Also you may want to run the seat belt through the outside lap belt hole. It will hold you in place better.
#4
Agent Orange
Rennlist Member
Rennlist Member
Not sure on price, try Ebay and dismantlers for that. If you're getting used ones make sure they are from a 993 because the seat belt standards changed several times in the 90s.
#5
Agent Orange
Rennlist Member
Rennlist Member
Wow! I responded to your question but it was posted ABOVE your answer. Does that mean I can travel through time? Anybody want this coming Friday's Mega Millions numbers?
#7
Agent Orange
Rennlist Member
Rennlist Member
Trending Topics
#8
Rennlist Member
#12
Three Wheelin'
Thread Starter
Join Date: May 2004
Location: SH, NJ
Posts: 1,317
Likes: 0
Received 0 Likes
on
0 Posts
Thank you for the help sofar. This is what I wanted to do. The L bracket goes under the rail and the receptor is attached to the L bracket. Thoughts?
#13
Instructor
When using rear seatbelts receptor how to deal with the presence wire ?
(actually are there any presence signal taken on the front seats ? guess no from my couch...)
(actually are there any presence signal taken on the front seats ? guess no from my couch...)
#14
Correct, you need another bolt though, also I used the rear seat belt receptacle too because I wanted mine down below the seat side hole so that there would be no interference w/ a 6pt harness. But one of the 997 receptacles might be a better choice if you don't run dual street/race setups, they come in several different lengths
#15
These are the 997 receptacles
the whole shebang mounted in the car, you can see how low the 993 rear receptacle is
most of us mount the RS mount between the siderail and the slider, not under the slider, you want it to move w/ the seat
the whole thing assembled before installation
the whole shebang mounted in the car, you can see how low the 993 rear receptacle is
most of us mount the RS mount between the siderail and the slider, not under the slider, you want it to move w/ the seat
the whole thing assembled before installation