Esco Flat Top Jackstands - Group Buy - $65ea
11-03-2008, 07:33 PM
#62
Advanced
Thread Starter
Join Date: Aug 2002
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
11-04-2008, 08:49 PM
#69
Drifting
11-09-2008, 08:08 PM
#71
Advanced
Thread Starter
Join Date: Aug 2002
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
All of the jackstands from the original group buy have now been shipped except for 2 people....Brent Strickler and Harold Ryan Ochs. If Brent or Ryan reads this, please contact me asap regarding your order. Thanks. Steve
11-12-2008, 04:19 PM
#73
Advanced
Thread Starter
Join Date: Aug 2002
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Post/Pin clearance issue - latest Esco jackstands
It has come to my attention today that some customers are having problems sliding the large pin (approx 13.8mm) into the all of the 5 holes in the posts of the Esco jackstands. These are holes to set the jackstand height.
In some cases, it is a simple burr obstructing the pin travel and others it appears to be a bit too much galvanized coating. I've been able to easily remedy the situation on all that I've seen with problems with a round file or a cordless drill (using a 1/2" or 13mm/13.5mm drill bit). I've contacted Esco to let them know about this issue.
If you can't get the pin through and are unable to clean the post holes, you can send the posts and pins back to me and I'll turn them around the day received.
Looks like I'll have to unwrap each of the posts in the boxes when received and do a test fit of the pins before shipping anything out in the future.
Please feel free to call me at 201-262-0412 if you have any questions.
Steve D
In some cases, it is a simple burr obstructing the pin travel and others it appears to be a bit too much galvanized coating. I've been able to easily remedy the situation on all that I've seen with problems with a round file or a cordless drill (using a 1/2" or 13mm/13.5mm drill bit). I've contacted Esco to let them know about this issue.
If you can't get the pin through and are unable to clean the post holes, you can send the posts and pins back to me and I'll turn them around the day received.
Looks like I'll have to unwrap each of the posts in the boxes when received and do a test fit of the pins before shipping anything out in the future.
Please feel free to call me at 201-262-0412 if you have any questions.
Steve D
Last edited by Steve D'Gerolamo; 11-12-2008 at 05:09 PM.
