Q: Heigo rollbar install for 993 RS
#1
Intermediate
Thread Starter
Q: Heigo rollbar install for 993 RS
I have bought the Heigo half roll-cage (516.041 see attached picture) which bolts into the seatbelt anchoring points. Having checked the archives, I specifically have the following questions regarding the install;
1. The anchoring points for the rear gearbox supports, are these pre-drilled. (I have heard this maybe the case but some conflicting information on this point...) Secondly, do I need to get in under the car to fasten the washer and nut?
2. The rear cross supports, here I understand that one needs to drill through the car into the rear wheelarches. Any favoured position to drill or things that I should watch out for?
Any advice would be most welcome.
PS. If you get the chance, buy a 993 RS it's such a blast... I will never regret my purchase.... Each time I drive the car I get such a grin on my face, its night and day compared to my previous stock 993 C2.
Thanks
1. The anchoring points for the rear gearbox supports, are these pre-drilled. (I have heard this maybe the case but some conflicting information on this point...) Secondly, do I need to get in under the car to fasten the washer and nut?
2. The rear cross supports, here I understand that one needs to drill through the car into the rear wheelarches. Any favoured position to drill or things that I should watch out for?
Any advice would be most welcome.
PS. If you get the chance, buy a 993 RS it's such a blast... I will never regret my purchase.... Each time I drive the car I get such a grin on my face, its night and day compared to my previous stock 993 C2.
Thanks
#3
Rennlist Member
Jonas,
e-mail Thom Schmitz at H&S Automobile and ask him. He will know the answer. I can't help you cos mine was already in the car (3rd hand).
Here's the e-mail: info@911-rs.de
Harry
e-mail Thom Schmitz at H&S Automobile and ask him. He will know the answer. I can't help you cos mine was already in the car (3rd hand).
Here's the e-mail: info@911-rs.de
Harry