Cm09578

I know many have already achieved a 9.xx second 1/4 mile pass with their Turbo and Turbo S. Would love to see a list of those that have done it and with what mods they did it with!!!

hcvone

I know my car can run in the 9's on 100 octane, Kline headers, exhaust, 100 cats, By Design intercoolers, IPD plenum and Y pipe and COBB, in the fall my corvette engine builder rents a local track for the day, so then we will see

Cm09578

Nice! Running stock tires?

hcvone

I have CF201 Forgeline with pilot super sports, but have cup tires and plan on putting them on the stock wheels for the track. Fries the stock Pirelli's from a punch like you're on wet leaves

8SecDD

Ran 9.4 @148mph with ES Motor 750 package installed by AIM Performance in South Plainfield, NJ.
Stock motor, stock PDK trans, stock fuel system.

ESMotor 71mm VTG Turbos
ESMotor intercoolers
AIM Straight Pipe Exhaust
ESMotor headers
IPD Plenum
IPD Y pipe
meth kit
Lightweight Tecnocraft seats
OZ Wheels
Cobb tuned by Emre Levent

Vid here:

Cm09578

8SecDD

Not very.
Once you are in them they are bearable, but nowhere near as comfy as stock seats. They also sit low and only slide forward and back. They are best for racing only. Then swap back in stock seats for daily driving.

8SecDD

Need to correct one thing. Wheels were HRE R101 LWs. OZ wheels were replaced by this time.

Nanook

I am not worthy to post here but for interest sake I ran a 10.1 with Sam's magic sauce stage lV and MS109 go juice...da if I recall was mid 2000's

Cm09578

Nanook

R888 rear,...stock fronts

8SecDD

Nice time. Quick car. What was your 60'?

Nanook

Thanks 9sec..1.5XX

8SecDD

Get some Mickey Thompson ET Street S/S's out back. Might be just enough to get you into the 9s with 1.4x 60 ft.

hcvone

Seen this car run, very impressive for sure