The Official 991 GT3 pic thread
#2073
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Motorwerks Autogroup Porsche 991 GT3 w/ BBi Roll Bar & Sparco Seats
Attachment 1343154
Vehicle Specifications
Attachment 1343155
Attachment 1343156
Attachment 1343157
Attachment 1343158
Attachment 1343159
Attachment 1343160
Attachment 1343161
About Motorwerks Autogroup
Address: 5704 Southwest FreewayHouston, TX 77057
Phone:832-419-8084
Facebook: http://www.facebook.com/Prestige-Mot...30329697102649
Facebook: www.instagram.com/motorwerks/
- Jerry@BBiAutosport.com
Attachment 1343154
Vehicle Specifications
- BBi StreetCup Roll Bar
- BBi Seat Base Kits (2)
- Sparco Racing Seats
Attachment 1343155
Attachment 1343156
Attachment 1343157
Attachment 1343158
Attachment 1343159
Attachment 1343160
Attachment 1343161
About Motorwerks Autogroup
Address: 5704 Southwest FreewayHouston, TX 77057
Phone:832-419-8084
Facebook: http://www.facebook.com/Prestige-Mot...30329697102649
Facebook: www.instagram.com/motorwerks/
- Jerry@BBiAutosport.com
__________________
Bringing Passion, Artistry, Craft to the Porsche Tuning Industry
Southern California's Porsche Performance Tuning, Engine Development,
ECU Software Tuning, Custom Fabrication, Race Preparation & Factory Service Center
Website: www.bbiautosport.com Email: sales@bbiautosport.com Phone: (714) 843-0200
Follow Us On: Facebook & Instagram
Bringing Passion, Artistry, Craft to the Porsche Tuning Industry
Southern California's Porsche Performance Tuning, Engine Development,
ECU Software Tuning, Custom Fabrication, Race Preparation & Factory Service Center
Website: www.bbiautosport.com Email: sales@bbiautosport.com Phone: (714) 843-0200
Follow Us On: Facebook & Instagram
#2075
Burning Brakes
#2076
Instructor
The following users liked this post:
9872SpeedYellowCS (04-13-2020)
The following 2 users liked this post by Tim H:
BlazinPond (04-04-2020),
typehxr1 (12-19-2021)
The following users liked this post:
RossP (11-14-2021)
#2080
I’ll add one more
The following 5 users liked this post by kart driver:
17bhub (04-05-2020),
BlazinPond (04-04-2020),
BountyHunter (04-05-2020),
kage65 (05-11-2020),
Unframed (04-05-2020)
The following users liked this post:
Captain_ (01-22-2021)
#2084
Rennlist Member
That looks fantastic. Curious how you made your side trim to fit the cup lip? I've been considering the cup lip and rear gurney flap also so I don't have to run canards.
The following users liked this post:
michaeldorian (01-01-2021)