Hi All
FYI The turn around time is now usually under a week for these covers ... Best regards Ed |
Originally Posted by Crazy Eddie
Hi All
FYI The turn around time is now usually under a week for these covers ... Best regards Ed |
Don't forget the headrest covers too!
https://i.imgur.com/YhbBdeA.jpg |
Originally Posted by Dr.Bill
(Post 14917375)
Don't forget the headrest covers too!
https://i.imgur.com/YhbBdeA.jpg |
Originally Posted by Dr.Bill
(Post 14917375)
Don't forget the headrest covers too!
https://i.imgur.com/YhbBdeA.jpg |
Originally Posted by Dr.Bill
(Post 14917375)
Don't forget the headrest covers too!
https://i.imgur.com/YhbBdeA.jpg |
That vertical tab of material will save your CF from being scratched if you use a Simpson Hybrid S. I have the marks on my cover to prove it. The cover paid for itself the first time I used it.
|
3 Attachment(s)
If you use the Hybrid HANs you need to protect your LWBs. I went this route where I installed protective covers over the screw holes.
Chet |
Originally Posted by Dr.Bill
(Post 14917375)
Don't forget the headrest covers too!
https://i.imgur.com/YhbBdeA.jpg |
Good Eye. I was about to ask how much the GT3 stitching would cost with CXX but this is smart because even if I got it the stictched CX on the buckets, I would still need protection anyhow. |
Originally Posted by RFGGT3
(Post 14923419)
I think you might have the rear bolster covers reversed; driver side vs. pass. side. The stitched velcro side should be on the inside of the seat. I did the same thing with mine and Ed pointed it out to me.
Maybe I got a set for a RHD car. LOL |
Originally Posted by Mech33
(Post 14922154)
The most cost-effective way to get GT3 stitched on the headrests!
Originally Posted by Alan C.
(Post 14922200)
That vertical tab of material will save your CF from being scratched if you use a Simpson Hybrid S. I have the marks on my cover to prove it. The cover paid for itself the first time I used it.
Best guys Ed |
Originally Posted by RFGGT3
(Post 14923419)
I think you might have the rear bolster covers reversed; driver side vs. pass. side. The stitched velcro side should be on the inside of the seat. I did the same thing with mine and Ed pointed it out to me.
|
Originally Posted by TRAKCAR
(Post 14819893)
Better get some Lizard green thread on order...
Originally Posted by Jamie140
(Post 14830936)
I would imagine acid would be popular too.
I have both in stock https://cimg1.ibsrv.net/gimg/rennlis...92780b2f7a.jpg Here is a comparison of the colors |
Have red stitch ones in GT4 and here are platinum stitch in GT3. Looks great and I would not let anyone sit in car until these were installed. Chet https://cimg8.ibsrv.net/gimg/rennlis...649f285d4.jpeg |
All times are GMT -3. The time now is 05:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands