When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Finally got my car with LWB and first thing was to call up Ed to have a set made with platinum stitching. I was lucky to have Ed's help to put it on, and see his awesome garage
They do not disappoint, very well made !
Thanks again for the awesome service and great product! Also got sneak peak of the latest products that he is working on, definitely call him up to complete your interior look !
Installed mine last night - these bolster covers are a masterpiece. Identical look and fit compared to stock. Actually they look better because deviated stitching is added to the rear piece. Amazing work, easy install, A+++ customer service. Thanks Ed!
I installed these in my RS back in mid-December - they are working great. Went with black w/silver stitching for the primary bolster covers and just the plain black leather for the smaller, secondary bolster pads (to match the stock interior as much as possible). Highly recommended! Thanks Eddie.
ed's are best
but. the dude decides to visit Carlsen instead of installing mine....
what is up with that.
Ed was awesome, he had mine in stock and shipped it out the same day I ordered! Then he went on that trip! He told me I got my set faster than anyone else! Just perfect timing. I just installed them today, only somewhat trick part but really wasn't, velcro tape at back for strap and where to thread it through. After I did the drive side, passenger was so much faster.
i cannot, for the life of me, get the power seat button to "pop out" in my 991.2 RS---never had a problem installing these in my 991.1 GT3 nor in my GT4.
Is anyone having troubles with this?
I can't get the little black plastic bezel to clip onto the toggle switch surround because it seems as though the switch is "fixed in place" as opposed to my other cars
i cannot, for the life of me, get the power seat button to "pop out" in my 991.2 RS---never had a problem installing these in my 991.1 GT3 nor in my GT4.
Is anyone having troubles with this?
I can't get the little black plastic bezel to clip onto the toggle switch surround because it seems as though the switch is "fixed in place" as opposed to my other cars
help!
Mine were a but tight, did you try the push from behind method? For the driver I got it out from top but passenger went underneath and pushed
Mine were a but tight, did you try the push from behind method? For the driver I got it out from top but passenger went underneath and pushed
Yes, tried that for quite some time
finally had to use needle nose pliers and some small watch tools but I finally got it and they look great.
I think the passenger seat may have been some factory defect (gasp), as the driver s side took 2 seconds as with my other two GT cars.
I did passenger seat first because I was over there finishing up hardwiring my radar detector to the D2 slot in the passenger footwell fuse box.
03-11-2019, 07:53 PM
[
