When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Bryan from Florida ran his new Manthey Racing water tank at Sebring last weekend. He reported the following:
“Tank worked perfect! I was burning about 1.5 -2 gallons during a 30min session (70* temp). On an 80* day I was burning a full tank in 15min, so tank is a life saver. Thanks again for getting these in for us ����”
Great to see folks here in the US already putting these GT2RS to work in their natural environment. Thanks for the picture and testimony, Bryan. Keep it up!
Plenty of components, both street and from the race cars. Send us a PM or email at info@311RS.com and we'll give you the full list.
Originally Posted by Larry Cable
they are stunning what's the price on a set for the GT3 (not RS)?
That photo sold us on those for the GT3. Typically we're all about the E88s, but these in Magnesium make a great case for themselves. They are €14,277.31 and available in the colors listed below.
Originally Posted by Nizer
What colors are available for the Manthey wheels?
As noted above, thanks Larry Cable:
- brilliant silver, platinum silver, satin black or gold (GT2RS)
- silver / black / titanium (GT2RS)
- gold / black / titanium (GT3)
Originally Posted by Gasman85
Can you see what the cost and availability is for the carbon GT3 wing? Thanks
Originally Posted by Larry Cable
+1
Originally Posted by 993RSCS
+2
The Manthey Racing GT3 wing is €4,193.27 and is currently in stock.
Originally Posted by Szpet
The wing is really big but very discreet.
When we saw that car in person in September, the larger wing was hardly noticeable. Until you notice it, then you cannot stop looking. It looks great and makes serious downforce. Here's a few more pics we took of the car while there:
^^^^
The additional downforce on a GT3 would be great but what needs to be done to balance it out on the front end? 311RS, can you comment?
Manthey's solution appears to be a 991 Cup front lip, KW 3ways, and some serious rake front to rear. We'd probably add some more front tire to our setup.
Manthey's solution appears to be a 991 Cup front lip, KW 3ways, and some serious rake front to rear. We'd probably add some more front tire to our setup.
Never seen anyone run the front cup lip on the regular bumper. Are there higher res pics of this? Curious to see what the sides look like up close since they're missing the vertical trim pieces that connect to the cup fender flares.
01-10-2019, 03:34 PM
