Oldmxnut

Chasing front plate registration holders for GT3 front. I searched on here but couldn't find any solutions that might work for me. Wondering if anyone has some ideas. In the past I have used double sided tape as the plates we had here in Australia where made from 3mm perspex and had a bit of flex. This new plate is hard plated. 100mm x 372mm . Any ideas. ?

Filoize

I'm fitting an adhesive front plate, having it made original size etc but adhesive.
Don't know if it's legal there.
You could debate that a proper plate can't be fitted because the car can't be pierced?

Cormid

There are plate holders that use front tow hook to attach

Cormid

The Platypus License Plate Mount for Porsche 911 (991) WITHOUT Parking Sensors | 2012-2016 | No Drilling | Installs in Seconds | Made of Stainless Steel & Aluminum | Made in USA

Oldmxnut

Thnaks for the suggestion, but unfortunately won't work. In Australia, if mounting off centre, it needs to be on the left side (so our speed cameras can see them clearly ) .. Plate size is actually quite narrow. ( 4in x 14.6 inches) . Its a pity it has a metallic back (two heavy for thin contact area) plate otherwise would try double sided adhesive tape. Ideally Im thinking about if there was a moulded form that fit the nose section but wasn't oversize.

not my plate but here is an example. Surround and back is a metal plate with sections to mount flat head screws to connect into front of car.. not keen on that!