Need to know if enough interest in Singer style shift knobs
10-14-2014, 01:24 AM
#16
Race Car
What's it weigh SDaddy?
But on looks I'm in as long as it's not Ali ie needs to be (declan?) plastic coated
But on looks I'm in as long as it's not Ali ie needs to be (declan?) plastic coated
Last edited by HiWind; 10-14-2014 at 01:41 AM.
10-14-2014, 04:46 AM
#19
Three Wheelin'
I think 100 pcs at right quality & price will shift easy enough - obviously you will need to finalize spec & price for solid commitment so post a drawing with final spec and price.
10-14-2014, 12:27 PM
#22
Rennlist Member
Thread Starter
Join Date: Jun 2014
Location: Tennessee
Posts: 982
Likes: 0
Received 0 Likes
on
0 Posts
I'll ask if he can do 6 spd pattern. Not sure if he would have to make a certain number to do a run of those,too. I think he said it weighed 13oz.
Hiwind, i think he said it is hard anodized.
Hiwind, i think he said it is hard anodized.
10-14-2014, 04:49 PM
#27
Rennlist Member
Thread Starter
Join Date: Jun 2014
Location: Tennessee
Posts: 982
Likes: 0
Received 0 Likes
on
0 Posts
In my mock up? That's a 10cc syringe that i sharpied silver,lol!
I think that will be very easy to source. Just has to be the correct diameter and tap it into place. One the **** is tightened on there it wont budge. I will be getting the prototype probably on Friday. I will post a few more pics then.
I think that will be very easy to source. Just has to be the correct diameter and tap it into place. One the **** is tightened on there it wont budge. I will be getting the prototype probably on Friday. I will post a few more pics then.
10-14-2014, 07:26 PM
#29
Rennlist Member
Join Date: Oct 2007
Location: Racking up air miles....
Posts: 3,663
Likes: 0
Received 557 Likes
on
246 Posts
I'd buy one with the 901 pattern as shown in the first post... Would need to know the width where the know meets the shaft as I have a rennshift shifter.
