Front spoiler - Rennspeed Gt-2
 

Recently picked up a '91 964 and I'm fortunate to have an original RSA deck lid and tail that I'm going to install.

Anyone done this before?

I'm also thinking that with the greater downforce in the rear I should add a Rennspeed GT-2 front spoiler to balance things out.

Any other comments?

Thanks

I run this front splitter with about 2' of the center section removed on my RS America Race Car. For the rear wing I use a 3.8 RS deck lid. For PCA I run a standard blade with 1/4" Gurney Strip at maximum angle of attack. For NASA I remove the standard blade and run a 50" Getty Design Evo1 Wing. This all works well but who really knows without a wind tunnel. The full GT2 front spoiler may be a bit too much with a stock RS America Tail.

JF

Thanks for the info JF.

It appears the front spoiler in your picture is similar to the GT-2 that I'm talking about adding. Your wing is obviously bigger. Are you saying the one you have pictured with 2' removed would be too big with a standard RS wing?

Thanks

....yeah its been done

http://i156.photobucket.com/albums/t...6/DSC01371.jpg


http://i156.photobucket.com/albums/t...6/DSC01367.jpg