Problems with a Dynapac dyno and a C4
 

Are there anybody on here that have successfully done a dyno pull with a C4 on a Dynapack system ? (www.dynapack.com)

I tried this today and the operator did not want to complete the pull. Power readings on all four wheels increased in parallell untill a speed of about 30-40 km/h then all of a sudden the power reading on the right rear wheel dropped to zero and on left it increased.

We tried over and over, but the same happened. Removing fuse 16 for ABS and PDAS (I believe) did not change the behaviour at all.

The operator thought the behaviour was due to the "traction controll system" not coping with the virtual environment.

Any ideas ?