FS: 2.5" IC Hard Pipes with BOV
#1
Rennlist Member
Thread Starter
FS: 2.5" IC Hard Pipes with BOV
2.5" stainless steel hard pipes for stock IC (or larger with correct adapters)
-2-bolt BOV flange with GReddy Type S BOV (appears to be authentic based on the casting marks). GReddy Type S can be setup for recirculating with the right hoses, or just run as BOV if you're running standalone with MAP sensor.
-Factory banjo bolt connection was tapped for a GM IAT sensor for pre-IC temp, has since been JB welded with a bolt to seal.
-Machined ends to help prevent couplers from sliding off
-Spray paint is peeling off
-No couplers provided
SOLD
by https://www.flickr.com/photos/alxdgr8/, on Flickr
by https://www.flickr.com/photos/alxdgr8/, on Flickr
by https://www.flickr.com/photos/alxdgr8/, on Flickr
by https://www.flickr.com/photos/alxdgr8/, on Flickr
Few years back when I had them on my car (works with stock IC as well with the right couplers)
by https://www.flickr.com/photos/alxdgr8/, on Flickr
-2-bolt BOV flange with GReddy Type S BOV (appears to be authentic based on the casting marks). GReddy Type S can be setup for recirculating with the right hoses, or just run as BOV if you're running standalone with MAP sensor.
-Factory banjo bolt connection was tapped for a GM IAT sensor for pre-IC temp, has since been JB welded with a bolt to seal.
-Machined ends to help prevent couplers from sliding off
-Spray paint is peeling off
-No couplers provided
SOLD
Few years back when I had them on my car (works with stock IC as well with the right couplers)
Last edited by alxdgr8; 02-15-2017 at 05:08 PM.