TonyG > New Race Car Build Thread
12-09-2013, 03:58 AM
#811
Nordschleife Master
Tony, what combination of drive axles and cv joints are you using? Were the stub axles changed on the gearbox to run 108 mm joints with stock 996 axles or is it setup using 996 outer and 944 inner?
12-09-2013, 11:13 AM
#813
Rennlist Junkie Forever
Thread Starter
We machined the transaxle stub axles to accept Boxter S outter CV race.
Then the entire rest of the CV (on the trans side) the axle and the other CV is all 996/997 TT.
TonyG
12-09-2013, 11:16 AM
#814
Rennlist Junkie Forever
Thread Starter
TonyG
12-24-2013, 02:25 PM
#816
Drifting
Join Date: Aug 2009
Location: Bangkok, Thailand, Milpitas, CA & Weeki Wachee, FL
Posts: 2,239
Likes: 0
Received 2 Likes
on
1 Post
Cool!!! Great job Tony!
Do you think it could have fired any quicker? No BS, that was seriously the first time you tried to fire it and it hit that fast? 👍👍👍
Do you think it could have fired any quicker? No BS, that was seriously the first time you tried to fire it and it hit that fast? 👍👍👍
12-24-2013, 03:18 PM
#818
Rennlist Junkie Forever
Thread Starter
But that was the first start of the car.
Then we got to deal with a power steering leak and three oil leaks. While I was dealing with the leaks, Jeff was programming the Racepak IQ3 dash and the Smartwire.
Then I had to go home because it was 2am on Christmas eve.
We'll resume dealing with the car Thursday. Then it's back off to Vision.
TonyG
12-24-2013, 05:01 PM
#824
Three Wheelin'
Congrats Tony. Absolutely amazing project to follow. I'd love to stop by Vision when it's there again and check it out.
When are you planning a track session?
When are you planning a track session?
12-24-2013, 05:44 PM
#825
Rennlist Member
Great to hear/see Tony. Hope it's going to be on the Track really soon. What's the ETA?
