Buy, sell or swap rods?
#1
Racer
Thread Starter
Buy, sell or swap rods?
I have a set of Pauter rods that are 5.850", stock is 5.906". They were used to knock the compression of a 3L 8 valve motor down from about 9:1 to about 8:1.
I want to go to a standard rod length.
If you want to buy these; swap for Pauters, Carillos or similar; or just have a set of those to sell, PM me.
West
I want to go to a standard rod length.
If you want to buy these; swap for Pauters, Carillos or similar; or just have a set of those to sell, PM me.
West