question about turbo cup car hood latch d-ring
#1
question about turbo cup car hood latch d-ring
I have a Canadian Turbo Cup car and on one of the hood latches, the d ring handle is bent to the point it has come loose from the base piece. I have a picture of the correct piece, but after doing a lot of looking on the internet, i have not found one. They have a pin on the bottom that allows the fastener to stay captive in the hood. Does anyone have any of these nos, or know if any are still made(doubtful), Here is a pic of the correct piece, along with a pic of the car.
Thanks
Scott
Thanks
Scott
#3
Rennlist Member
I have some NOS of these. I've searched hi and low and none of the camloc stuff suits or if it does it is NLA and requires massive minimum order quants. PM me and we can work something out.
The following users liked this post:
cjd92 (09-04-2022)
#7
Rennlist Member
Not heard form you but I'm guessing this is what you are looking for. They are Porsche Motorsport parts from the 962 le mans parts bin. Obviously used on the 944 Cup Cars too, Part number 962 521 521 00. NLA from Porsche. I have a few spare that I'm saving for a Turbo Cup bonnet project that is still in its early stages. PM me if you want me to send you one.
Trending Topics
#9
Rennlist Member
#10
Rennlist Member
Not heard form you but I'm guessing this is what you are looking for. They are Porsche Motorsport parts from the 962 le mans parts bin. Obviously used on the 944 Cup Cars too, Part number 962 521 521 00. NLA from Porsche. I have a few spare that I'm saving for a Turbo Cup bonnet project that is still in its early stages. PM me if you want me to send you one.
Hope you realize that TC hood project Paul.
/Peder
#11
Rennlist Member
#12
Rennlist Member
The following users liked this post:
Voith (06-10-2022)
#14
Beamishnz,
Do you happen to still have the bail handle 1/4 turn camloc studs available? Do yours have a "13" stamped on top? I'm looking to purchase if you still have extra on hand. Thanks.
-RS
Do you happen to still have the bail handle 1/4 turn camloc studs available? Do yours have a "13" stamped on top? I'm looking to purchase if you still have extra on hand. Thanks.
-RS
The following users liked this post:
PF (06-08-2022)