Those running KLA upper strut mounts...
#1
Pro
Thread Starter
Those running KLA upper strut mounts...
Is the nut on top suppose to fit like this? I feel like the nut should be narrower or not recessed into the hole so much. 1987 951 with Sachs Super struts and Weltmeister springs.
#3
Rennlist Member
Looks like the correct top nut but there should be an aluminum conical washer / spacer installed over the strut pin just below the nut.
#4
Pro
Thread Starter
#5
Rennlist Member
I use Racer's Edge camber plates which came with these, I'm assuming you need something similar.
Edit: Although, the KLA Mount shows four washers suggesting one on each side of the bearing...you might reach out to them and see what they recommend.
Edit: Although, the KLA Mount shows four washers suggesting one on each side of the bearing...you might reach out to them and see what they recommend.
Last edited by mj951; 08-11-2019 at 12:53 PM.