West Germany part ?
#1
Drifting
Thread Starter
West Germany part ?
I ordered a new transmission input shaft seal from a well-known online Canadian distributor; this is what they sent. The box appears modern.. but.. is this really a New Old Stock??
In any case, I tried to install it, but ran into an issue. If interested, see other thread.
In any case, I tried to install it, but ran into an issue. If interested, see other thread.
#2
Drifting
Thread Starter
Ok, I peeked on a well-known 944 parts supplier's page with pics of the current seal and it's the same. Does look a little 'old' though! I guess the "W. - Germany" isn't NOS. Funny, the (most likely original) seal that came out looks a lot newer (sorry--it's chewed up from removal).
Note the VW / Audi on the seal that I pulled
The other surprise is the Rear Main Seal--it's the Elring. Given that the clutch disk I pulled has "8 / 87" stamped on it (the car is a 1988 951), I suspect Elring was the OEM at that time. Oh, and the clutch disk is the "HD" type without the six smaller springs
Note the VW / Audi on the seal that I pulled
The other surprise is the Rear Main Seal--it's the Elring. Given that the clutch disk I pulled has "8 / 87" stamped on it (the car is a 1988 951), I suspect Elring was the OEM at that time. Oh, and the clutch disk is the "HD" type without the six smaller springs
#4
Addict
Rennlist Member
Rennlist Member
Matrix for making those is probably old 30 something years so it's still W Germany. It doesn't make sense to modify or produce new matrix for seals made in small batches just because germany is no longer separated.
The seal you have was made with original porsche matrix with part number but because it was sold to you bypassing Porsche someone had to hand dremel the part number off.
The seal you have was made with original porsche matrix with part number but because it was sold to you bypassing Porsche someone had to hand dremel the part number off.
#5
Drifting
Thread Starter
Yes, I noticed that odd rubbed out section. The metal does look old and tarnished.. and the rubber kinda dull; in fact, it feels a little hard compared to the soft rubber on new drive axle seals I also got
The same supplier sent 2 transmission drive axle seals which look like the image on their site for the input seal. Very modern.. rich black and softer. These came in Elring boxes.. but oddly don't say Elring on the seal face
The same supplier sent 2 transmission drive axle seals which look like the image on their site for the input seal. Very modern.. rich black and softer. These came in Elring boxes.. but oddly don't say Elring on the seal face
#6
Drifting
Thread Starter
Got a new input shaft seal from Porsche. Same as the one I first bought... but the "VW / Audi" marks and part number are not rubbed out, obviously. Funny it's VW / Audi, but that's what's on the transmission anyway