dreygata

I'm working on gapping my speed/reference sensors, but I wanted to know what the third sensor off to the side in that bracket is (connected with a standard fastener) and where it's supposed to hook up. When I took my engine out of the car, the connector was just capped off and wasn't connected. It's a round connector.
It's the lower sensor in this image

V2Rocket

thats an unused diagnostic sensor, ok to leave it capped or just remove it entirely

Martin1986

I have a faulty crank sensor 600kohms. I got the car on jack stands but do not see the sensors. How do I get there?

martin

walfreyydo

Below the fuel rail near the firewall. Hard to reach.
https://www.pelicanparts.com/techart...eplacement.htm

All 8V cars have them in the same spot, so even though the above article references a turbo, its actually easier for the non turbo cars. If you have a 16V car there is only one sensor, but same rules apply.

Martin1986

found them. Posted a picture in this thread for anybody interested

https://rennlist.com/forums/showthre...2&goto=newpost

its behind the rear driver side wheel.

Peteinjp

Wrong thread