OIL FILLER INSTALL 85 928S 32v
#1
Rennlist Member
Thread Starter
OIL FILLER INSTALL 85 928S 32v
Can anyone describe the oil filler install for my 85 928S 32v.
I just got it back from powder coater.
I have new gaskets and honda lube.
Also where does the small black plastic "check valve" go?
I want to put it on right, with no leaks!
I have 2 paper gaskets which are the shape of the base, and the rubberband looking gasket.
I just got it back from powder coater.
I have new gaskets and honda lube.
Also where does the small black plastic "check valve" go?
I want to put it on right, with no leaks!
I have 2 paper gaskets which are the shape of the base, and the rubberband looking gasket.
#2
Racer
Join Date: Oct 2009
Location: Griffin, Georgia
Posts: 432
Likes: 0
Received 0 Likes
on
0 Posts
Attachment 599888 This might help a little, for the valve location. Check Dwaynes write up on the intake refresh, should help with the rest.
Last edited by jacal128; 04-22-2012 at 10:23 PM.
#4
Rennlist Member
The rubber piece I believe goes into the louvered baffle (I reused mine). Sandwich the baffle in between the two gaskets and use a very small amount of gasket sealer on each mating surface. The baffle has a marking on it to ensure you don't put it in upside down.
#7
Rennlist Member
Yes Roger send 2 paper gaskets for this purpose. Makes the neck seal better.
And yes the order you put them in above is correct. Use the sealer very sparingly. With the filler neck, 2 gaskets and baffle it is a bit of a bitch to get everything lined up.
And yes the order you put them in above is correct. Use the sealer very sparingly. With the filler neck, 2 gaskets and baffle it is a bit of a bitch to get everything lined up.