Need a WUR Bracket Cut
#1
Rennlist Member
Thread Starter
Need a WUR Bracket Cut
Hi everyone. I was hoping for some assistance. I need a new WUR bracket cut for my ‘79. I thought this was going to be easier than finding one off a parts car but….
I have an .ai, .pdf or ezcad file I can send along with some 1/8” aluminum plate. I was hoping my little 50w fiber laser would eventually do it but I don’t think it’s going to be able to. Can anyone help me out with a CNC or proper laser?
I have an .ai, .pdf or ezcad file I can send along with some 1/8” aluminum plate. I was hoping my little 50w fiber laser would eventually do it but I don’t think it’s going to be able to. Can anyone help me out with a CNC or proper laser?
#2
Three Wheelin'
i think i have that bracket.... but in Belgium
#3
Rennlist Member
What about Send Cut Send?
Cheers
Cheers
#4
Rennlist Member
Thread Starter
#5
Rennlist Member
Thread Starter
Hi Sir, what do you mean? I'm contemplating trying to figure out how I can create a jig that will allow me to cut on one side and then flip it over and cut from the back side. That would work better. I just don't have anyone around that does it. I have one place that might but of course they are closed today because of the storm. How's cbus?
The following users liked this post:
streetsnake (12-23-2022)
#7
Rennlist Member
@streetsnake : Sorry, I should have included a link. They sponsor some folks I watch on YouTube, which is why they're on my radar.
Cheers
Cheers
The following users liked this post:
streetsnake (12-23-2022)
Trending Topics
#8
Rennlist Member
Thread Starter
Success…Finally
I finally got it cut. I won’t be trying that again but at least it’s done. I’ll get it cleaned up and can finally start assembling some more of the top-end.