Early Car Console Plastic Needed
#31
Race Car
Hey guys, Sorry it's been a few weeks. There was a little delay getting the blank and I've been out of town on work for a week. At any rate Ron's blank arrived Monday and it is in excellent condition. It has the glossier surface from use but that's ok because the printer I am going to use for this one will, I believe, reproduce the OEM texture pretty close, we'll see.,
I have done an initial reverse engineering of the part which I will refine tonight. I hope to have prototype printed out before the end of the week ready for a check fit.
I have done an initial reverse engineering of the part which I will refine tonight. I hope to have prototype printed out before the end of the week ready for a check fit.
#32
Race Car
Hey Jim, not sure if you were referring to me as "project leader", but if so by all means go for it. I think those wanting to keep an original OEM part and have it restored to an OEM finish would love to have that option as well.
#34
Rennlist Member
Not sure if we're on the same page. I offered to send you a restored original texture pattern. That's all.
Reads like you have it covered. Thanks!
Reads like you have it covered. Thanks!
#36
Rennlist Member
#37
Race Car