928 Pro Tour LS3 / Z06 Build
#16
Rennlist Member
Thread Starter
Replaced steering shaft rubber donut. Replacement had different insert bushings so had to use stock bushings in new rubber.
Last edited by Blagave; 02-24-2018 at 06:19 PM.
#17
Shameful Thread Killer
Rennlist Member
Rennlist Member
Jeez, got to admire a guy who dives in the deep end.
What's the plan for the old Euro engine? Not to be ghoulish...
What's the plan for the old Euro engine? Not to be ghoulish...
#18
Rennlist Member
Thread Starter
Decided to delete sun roof, cut out sun roof sheet metal and member UNEEKONE was kind enough to sell me a roof panel and non sunf roof headliner. I spoke with painter / body man to figure out how to weld the filler piece in. I ended up recessing the edges approx 1/16th " so he would have some flexibility making everything blend.
#19
Rennlist Member
Thread Starter
Was going to tig weld, but it wasn't practical, so used mig welder. Lots of tack welds. I will grind and blend the best I can and then leave the rest for the painter to deal with
Last edited by Blagave; 09-24-2017 at 12:30 AM.
#20
Rennlist Member
Thread Starter
The motor that came out of the 83 conversion build is not the Euro engine.
I will be selling off the the motor, trans and torque tube down the road.
I will be taking all the smog equipment off the motor to use on my Euro car.
#22
Rennlist Member
Thread Starter
Received some of the parts from Renegade for LS swap. Installed the fly wheel, pilot bearing, clutch, pressure plate and bell housing. Hoping to get motor mocked up this weekend.
#23
Rennlist Member
Thread Starter
Now the pressure is on.
I Have read your thread numerous times and just love the detail that went into your build. People can appreciate the quality of your build, but until they have actually invested the time, sweat, research and money into a build of your stature, it is very hard to comprehend.
My goal is to come up just short of your build
I Have read your thread numerous times and just love the detail that went into your build. People can appreciate the quality of your build, but until they have actually invested the time, sweat, research and money into a build of your stature, it is very hard to comprehend.
My goal is to come up just short of your build
#24
Rennlist Member
Thread Starter
#26
Rennlist Member
Thread Starter
Built front frame stiffener and solid steering mounts. Will make some derlon washers to match over all stock length of steering rack bushings
Last edited by Blagave; 09-24-2017 at 12:35 AM.
#29
Rennlist Member