FS: 944 S2 stock and lightweight flywheels, bell housing, PP, clutch
#1
Race Car
Thread Starter
FS: 944 S2 stock and lightweight flywheels, bell housing, PP, clutch
I bought the stock S2 flywheel from Lart many years ago but wound up using 968 DMF, clutch/PP, bell housing and torque tube for my project instead. It's in very good used condition with no ridges on the friction surface. This is a good choice for 944 guys wanting a 60-2 setup. Asking $150 + shipping.
I also have a lightweight S2 flywheel which weighs about 10# [stock weighs about 15#] which had a Sachs clutch disk and PP in good used condition with plenty of life left. Asking $350 + shipping.
Finally, an S2 bell housing for mounting the flywheel timing pickup. Not sure what these go for, make reasonable offer + shipping.
Thanks.
I also have a lightweight S2 flywheel which weighs about 10# [stock weighs about 15#] which had a Sachs clutch disk and PP in good used condition with plenty of life left. Asking $350 + shipping.
Finally, an S2 bell housing for mounting the flywheel timing pickup. Not sure what these go for, make reasonable offer + shipping.
Thanks.