What did you do to your 924/944 today
05-25-2009, 10:52 PM
#47
Pro
Join Date: Oct 2005
Location: High Desert, So. California
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
Installed 2 Car amps. a 100W 4channel amp and a 200W 2 channel amp. The amps fit in a custom piece of plywood in the driver side cubby, with room to spare for my emergency supplies.
I have an Alpine 12 Ch eq I need to install and a sub box I built with an 8" Stillwater SoloBaric Sub that fits right behind the driver. Hopefully by next week I'll have the amps wired to the head unit. I already had power there from the P.O.
I previously installed some Alpine 5 1/4 speakers in the rear panels. I had to weld and make some special brackets for them to fit in the 4x6 openings but they sound better than what was there.
I have an Alpine 12 Ch eq I need to install and a sub box I built with an 8" Stillwater SoloBaric Sub that fits right behind the driver. Hopefully by next week I'll have the amps wired to the head unit. I already had power there from the P.O.
I previously installed some Alpine 5 1/4 speakers in the rear panels. I had to weld and make some special brackets for them to fit in the 4x6 openings but they sound better than what was there.
will install today and do an oil change
05-26-2009, 03:52 PM
#51
AutoX
Join Date: Apr 2008
Location: Buckinghamshire
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Waited by the phone hoping it was ready to be picked up after having a front end bare metal respray. I'm on holiday from the end of the week so it'd be nice to have it back for then.
05-26-2009, 08:33 PM
#53
The Impaler
Rennlist Member
Rennlist Member
05-26-2009, 08:40 PM
#54
Almost Addicted
Rennlist Member
Rennlist Member
Yesterday I cut out templates for all the components (amps, x-overs, capacitor) I need to install and figured out exactly how I'm going to finish my stereo install.
05-26-2009, 09:55 PM
#56
Advanced
Join Date: Jan 2007
Location: Naptown
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Replaced the HVAC control unit, steering wheel, clock, trim around ignition cylinder, sanded and repainted the gauge cluster housing (nice smooth black now), and replaced the clear plastic covering the gauges. Got all of that at the junk yard for 40 bucks. My interior has never looked better!
05-27-2009, 12:29 AM
#59
Pro
Thread Starter
fixed "that rattle" turned out to be one of the 2 muffler hangers lost a nut (giggidy) and caused the muffler to bang against the axle. While I had the car in the air doing an oil change, I discovered i need 2 front wheel bearings (unless they are a repackable type bearing?? anyone?)
