What did you do to your 924/944 today
#1533
Race Director
140k on the Turbo S.
Rod bearings are for the Turbo. I bet the are originals. I also have motor mounts for the turbo too and fear I have a pan gasket leak. I might have been just a front seal leak, but since I farking around with it all I figure do the pan gasket, rod bearings and motor mounts as well. I am also putting new ball joints in the control arms. Once that is all done I can tackle my A/C problem. Lots of work. Then again I have not done much work on this car in the past 5 years when I did a clutch. I have owned it since 1997 and put about 50k on it. It is just due for some loving right now.
Let me tell you I have forgotten how much harder it is to work on a Turbo. All the pumbing just make every job take longer than in my spec car iwth no A/C an no powersteering.
The spec is ready to race mechically. Cosmeticlly I need to do some bondo and paint work before nationals.
#1534
Rennlist Member
Join Date: Feb 2009
Location: Mississippi
Posts: 1,294
Likes: 0
Received 0 Likes
on
0 Posts
What did I do to my 944 today????
I purchased it!!!!!
Will create a thread on my new toy later tonight guys; and I hope everyone is in a good mood. I will be asking for ALOT of advice on it.
michael
I purchased it!!!!!
Will create a thread on my new toy later tonight guys; and I hope everyone is in a good mood. I will be asking for ALOT of advice on it.
michael
#1540
Instructor
Join Date: Feb 2010
Location: poughkeepsie, ny
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
#1543
Three Wheelin'
got my second flowmaster 50 series delta flow muffler in the mail today...it will be tied up to the other one i have, turned sideways and the dual 3 inch pipes run over the axle and to the two mufflers tomorrow....that's gonna be a lot of FUUUUUNNNNN fab work...woot!
#1544
Ordered Bilstein Struts, Weltmeister 200lb springs and Dansk polished exhaust. Scraped old state inspection an emissions stickers off since I licensed it with antique tags. Reconnected my reference sensor since the connectors separated causing a no-start condition earlier this week.
#1545
Instructor
Join Date: Sep 2009
Location: Marlborough, United Kingdom
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
I paid £993 for the Annual MOT, new brake pads and the sloppy gear change modification to be carried out.
Its getting expensive !!
Will pick the car up tomorrow.
Its getting expensive !!
Will pick the car up tomorrow.