AIM TPS on Porsche 968
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 18,677
Received 2,833 Likes
on
1,670 Posts
Did you determine you couldn't get it from an ECU pin?
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
#5
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 18,677
Received 2,833 Likes
on
1,670 Posts
I would imagine a string pot on the throttle bellcrank in the engine compartment would be best. Here is a pic of one on a Miata...
#7
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 18,677
Received 2,833 Likes
on
1,670 Posts
I think you could fab a bracket that is attached at the cable housing end on top and run the string pot around the pulley to the same attachment point as the throttle cable.
http://flussigmagazine.com/uploads/3...67132_orig.jpg
http://flussigmagazine.com/uploads/3...67132_orig.jpg
Trending Topics
#8
Rennlist Member
Thread Starter
Reviving an old thread. Still looking for a tutorial on installing my AIM TPS sensor on a 968. Finally got the brake pressure, RPM, etc working well. Now just need to figure out how to mount the TPS. Has anyone done this that could send me a picture of the bracket you fabricated? Thanks.
#9
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 18,677
Received 2,833 Likes
on
1,670 Posts
#10
Rennlist Member
Thread Starter
Originally Posted by ProCoach
#11
Reviving an old thread. Still looking for a tutorial on installing my AIM TPS sensor on a 968. Finally got the brake pressure, RPM, etc working well. Now just need to figure out how to mount the TPS. Has anyone done this that could send me a picture of the bracket you fabricated? Thanks.