DIY decklid porsche letters
#31
RL Community Team
Rennlist Member
Rennlist Member
Thanks. Yours does too and it's cool you're playing around with this, especially using the 3D printing technology. Keep up the good work.
Stinks those melted in the oven though. How hot was the oven and how hot will they get in the summer sun on your dark grey car?
Stinks those melted in the oven though. How hot was the oven and how hot will they get in the summer sun on your dark grey car?
#32
Rennlist Member
Thread Starter
200.. took 5 min to start melting. I normally bake for 20.
Yeah, same thought. Probably would have melted on the car in the hot sun.
Going to try a different mix with the printer.
Yeah, same thought. Probably would have melted on the car in the hot sun.
Going to try a different mix with the printer.
#35
Rennlist Member
Thread Starter
Thanks..Yeah, no good. I tried a different mix and it deformed at 150.
I see a lot of the emblems on ebay using abs so I must be doing something wrong.
Ordered some black acylic which supposedly melts at 320. We shall see.
I see a lot of the emblems on ebay using abs so I must be doing something wrong.
Ordered some black acylic which supposedly melts at 320. We shall see.
#36
Rennlist Member
Thread Starter
Couldnt get acylic to print without needing more work than it was worth.
Bought the black porache letters and dont know if i like it. End of day this diy is a fail.
On to the next project.......
Bought the black porache letters and dont know if i like it. End of day this diy is a fail.
On to the next project.......
The following users liked this post:
Darkboyz68 (02-04-2022)