driveopolis

I recently had an airbag light which durametric diagnosed as

800A Passenger's belt tensioner above upper limit.

Taking this to mean a hardware fault in the seatbelts, I replaced both seatbelts with fresh yellow ones from Suncoast. They look great and after the installation I read durametric again and there were no longer any airbag faults! Hurray.

However, despite durametric reporting no faults, my airbag light is still blinking. I tried resetting the ECU in durametric but still it blinks.

Any ideas? Have I missed a step?

Presto

Didnt want to start a new thread but im getting this exact same error.

800A Passenger belt tensioner above upper limit. Ressistance value is 4.3 Ohm compared to driver side which is 2.40 ohm.
Is seat belt replacement the only option?

Airbag light is on, reset it twice but it keeps coming back after driving the car for a while.