Do I need to take the cap off the reservoir when changing brake pads?
#1
Pro
Thread Starter
Do I need to take the cap off the reservoir when changing brake pads?
Getting set to do the first DIY brake pad change on this car. 05 997. I've got a great picture by picture DIY from this forum but I can't determine if I need to loosen or remove the brake fluid reservoir cap to allow for back flow of fluid when pushing the pistons back into the calipers. I've usually done this as a matter of course in the past but I don't see in mentioned in the tutorial I have. Thanks!
#3
Rennlist Member
in 3 years i've never taken cap off. it's a little harder to push back the calipers due to the pressure but no big deal. i think i asked the same thing on here awhile back and some chimed in that theyve been doing it this way for many many years with no issues. IIRC, the only issue actually brought up was if you do remove the cap, there's a better chance of you pushing fluid all over your trunk if youre not careful.
#4
Race Director
Getting set to do the first DIY brake pad change on this car. 05 997. I've got a great picture by picture DIY from this forum but I can't determine if I need to loosen or remove the brake fluid reservoir cap to allow for back flow of fluid when pushing the pistons back into the calipers. I've usually done this as a matter of course in the past but I don't see in mentioned in the tutorial I have. Thanks!
I always remove the cap and suction (use a turkey baster) to remove some fluid to ensure that when I spread the pistons before removing the old pads and to make room for the new pads to ensure that no brake fluid overflows the reservior.
Sincerely,
Macster.
#6
Three Wheelin'
Takes about 2 seconds to remove the cap and a few more seconds to remove some old fluid. Lots less time than it would take up to clean up any spilled fluid.
I always remove the cap and suction (use a turkey baster) to remove some fluid to ensure that when I spread the pistons before removing the old pads and to make room for the new pads to ensure that no brake fluid overflows the reservior.
Sincerely,
Macster.
I always remove the cap and suction (use a turkey baster) to remove some fluid to ensure that when I spread the pistons before removing the old pads and to make room for the new pads to ensure that no brake fluid overflows the reservior.
Sincerely,
Macster.
Trending Topics
#8
Race Director
Never removed the cap or had to remove fluid to change pads. I swap street to race pads every month...been doing this since 2006.