Cam positions between banks using durametric.
10-20-2015, 07:12 PM
#1
Track Day
Thread Starter
Join Date: Aug 2015
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Cam positions between banks using durametric.
Cam positions between banks using durametric.
Guys anyone got any examples of cam position sensors outputs in Durametric software, I am asking as I get a 0 on one bank and a moving target on the other usually about 0.4 to 1 degrees at the extremes.
This is with revving the engine, nothing crazy about 3k and back to idle...
Why one bank is always 0?
What is the cause of the variation?
What's normal / documented?
Guys anyone got any examples of cam position sensors outputs in Durametric software, I am asking as I get a 0 on one bank and a moving target on the other usually about 0.4 to 1 degrees at the extremes.
This is with revving the engine, nothing crazy about 3k and back to idle...
Why one bank is always 0?
What is the cause of the variation?
What's normal / documented?
