Power Seat Control Knob - Where to find a replacement
#17
Rennlist Member
nothing like a nice clear focussed photo
#19
Rennlist Member
there seem to be a lot of the boxster style seat ***** available - other than the mounting area being in a different location they look similar.
can these ***** be retrofitted to fit properly??
can these ***** be retrofitted to fit properly??
#21
Rennlist Member
Join Date: Jun 2014
Location: Duffy's Tavern
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
Power Seat Control **** - Where to find a replacement
Originally Posted by stasha
Wish I knew how to access the technology.
http://www.shapeways.com
#22
#23
Race Director
If there's really no source for these, it wouldn't be that hard to make one - I could make a silicone mold of mine and cast a few out of resin. They might not be absolutely perfect aesthetically, but I suspect I could make them functional.
If anyone still needs one of these, let me know (and ideally take a picture of the one you need) and I'll give it a try...
If anyone still needs one of these, let me know (and ideally take a picture of the one you need) and I'll give it a try...
The following users liked this post:
wesmoody (01-18-2021)
#26
Rennlist Member
You also have to remove the seat to work on any of the stuff in this control panel because the wires are all tightly tied underneath and need to be freed up enough to give you room to work behind the panel.
If you do remove the seat remember to keep the key far away so you don't mess up the air bag stuff while disconnected.
If you do remove the seat remember to keep the key far away so you don't mess up the air bag stuff while disconnected.
Last edited by rockhouse66; 05-21-2016 at 10:00 AM.
#29
Odd Posts
Rennlist Member
Rennlist Member
Thread Starter
Hi Guys,
I actually gave up, junked the seats and put in 997 GT3 seats .
If anyone wants to send me one, I will reverse engineer and make a bunch in ABS or Delrin
I actually gave up, junked the seats and put in 997 GT3 seats .
If anyone wants to send me one, I will reverse engineer and make a bunch in ABS or Delrin