Powder Coating Pulley Halves
#16
#18
Race Car
Hey. You know how I feel about the RS conversion...but...without going into all that, if you are going to keep the RS setup, and you want to make it all perty in there....why not go with the billet halves from rothsport?
http://www.rothsport.com/Products/En...ys-964-993.htm
Best bang for the buck I suppose if you want to clean it all up...
http://www.rothsport.com/Products/En...ys-964-993.htm
Best bang for the buck I suppose if you want to clean it all up...
#20
Drifting
Thread Starter
Ok, this is interesting. I bought a used upper alternator pulley set and the back halves came powder coated black. They do look good too.
Also, I have two sets of front halves. Both are different sizes. I'm assuming one is for tip and they other is manual. You know which is which? Smaller is tiptronic I think.
I'm going to go ahead and powder coat both and sell the one I don't need.
Also, I have two sets of front halves. Both are different sizes. I'm assuming one is for tip and they other is manual. You know which is which? Smaller is tiptronic I think.
I'm going to go ahead and powder coat both and sell the one I don't need.
Last edited by DobermanDad; 03-29-2015 at 01:03 PM.
#21
Drifting
Thread Starter
Went ahead and coating my halves this morning. I'll probably have to check them until the PC is worn off. But I got these used, they were in pretty sad shape, and now they look brand new. I almost just polished them.